SOLID BRASS SPACER 25mm x 10mm x M4. This is tapped both ends.
P/N 05-002 £ POA
BLACK NYLON SPACER
This is 2 inch or 50mm long and 1/2 inch or 12.5mm diameter.
There is a threaded M4 hole either end for screw fixing. It is ideal for mounting component boards.
P/N 05-005 £ POA
ZINC PLATE HEX SPACER 25mm x 8mm x M4
P/N 06-004 £ POA
P/N 13-001 £ POA
15-365pF. This is new manufacture. Supplied with two fixing screws.
Shaft size is 1/4 inch Dia x 7/8 inch long.
P/N 21-001 £ POA
SLOW MOTION DRIVE 36-1
plus 6-1. This is a superb slow motion ball drive containing both 36-1 ratio slow motion and 6-1
on the same drive. Turn the dial clockwise for 6-1 and anticlockwise for 36-1.
This is the flange type for mounting my dial plates directly.
P/N 25-001 £ POA
SLOW MOTION DRIVE 6-1
This is a single acting drive with Flange for mounting my Dial Plates. Jackson Brothers type drive.
P/N 25-002 £ POA
BLACK NYLON HEX PILLAR
This is 1 inch or 25mm long and 3/8 or 10mm fiameter. Hole size is M5. This has solid brass threaded stud
on one end plus threaded nylon hole other end. Suitable for insulating coils or for circuit board mounting.
P/N 25-004 £ POA
CHICKEN HEAD POINTER KNOB
This black plastic pointer knob has remained the same design since the 1930's.
It is a very authentic looking knob for the crystal sets.
P/N 23-001 £ POA
BLACK TAPERED FOOT
This adds the final touch to your projects. It is made from hard plastic and is fixed by
screwing to base. 15mm long x12mm diameter. M4 hole fixing.
P/N 24-001 £ POA
This simple chassis is suitable for Crystal and Regen Radios plus many small electronic projects.
The front panel is 8 x 6 inches (200x150mm approx)made from 18Gauge (1.2mm) Polycoated Aluminium.
The Chassis section is 8x6x2.5 inches and made from 20 Gauge (.75mm) Polycoated Aluminium